After Use, Cleaning, and Storage
Clean, inspect, dry, and store Serenity and its accessories after each session.
After Every Session
- End the session and confirm that stimulation has stopped.
- Remove the clips by holding the clips, not the wires.
- Disconnect the electrode cable from the controller.
- Remove all gel residue.
- Allow every component to dry completely before storage.
Clean the Components
- Wipe the controller with a soft cloth that is dry or only slightly damp.
- Use a soft cloth dampened with warm water and mild soap to remove gel from the electrode contact surfaces.
- Keep moisture out of the USB-C port, stimulation port, cable connector, and controller housing.
- Do not submerge the controller, cable, or clips.
- Do not use abrasive cleaners, solvents, or alcohol on the controller or accessory surfaces.
Inspect and Store
- Inspect the clips, cable, connectors, and controller for wear, corrosion, cracks, or other damage.
- Do not use a damaged or contaminated component.
- Coil the cable loosely; do not kink it or wrap it tightly around the controller.
- Store the dry controller and accessories in the carrying case.
- Keep the kit in a clean, dry location away from direct sunlight, extreme temperatures, and children.
Contact Zeno Labz when a clip, cable, or other accessory needs replacement.